Steel That Carries the Weight

Structural steel beam fabrication and reinforcement services for buildings and upgrades in Johnston, Colorado.

When you need to support a roof, open up a wall, or reinforce a structure in Johnston, the steel beams you install have to carry the load without deflecting, cracking, or pulling loose over time. Rhoades Welding LLC fabricates and installs structural steel beams designed for accurate measurements, secure welds, and long-term structural support.

This service includes fabrication of steel beams, installation for new construction or remodels, and reinforcement for buildings and structural upgrades. The work is suitable for commercial and agricultural structures, with a focus on safety and code-aligned fabrication. Each beam is measured, cut, and welded to fit the layout, and connections are inspected before the structure is loaded.

For structural steel work on your Johnston project, contact Rhoades Welding LLC to discuss load requirements, dimensions, and installation timing.

Beams Measured and Welded to Fit

Rhoades Welding LLC begins by reviewing your building plans or taking field measurements to confirm beam length, load capacity, and connection points. The steel is cut to length, and connection plates or flanges are welded in place before the beam is lifted and secured to the structure.

After installation, you will see beams that sit level, columns that hold plumb, and welds that show full penetration without gaps or porosity. The structure will support the intended load without sagging, and the connections will remain secure through daily use and environmental stress.

Reinforcement work includes adding bracing, sistering new beams alongside existing ones, or replacing compromised sections of a frame. The service does not include engineering calculations or permit applications, but the fabrication itself is performed to support structural integrity and code compliance. If the building requires temporary shoring during beam installation, that is coordinated with your contractor or builder.

What Property Owners Ask Before Starting

Homeowners and contractors in Johnston typically want to know how beam size is determined, how long installation takes, and what happens if the structure does not align with the plans once the walls are opened.

What types of structural steel work do you handle?
Rhoades Welding LLC fabricates and installs steel beams, columns, bracing, and reinforcement for residential, commercial, and agricultural buildings. The work includes new construction, remodels, and structural upgrades.
How do you determine the correct beam size?
Beam size is based on the span, load, and building code requirements provided by your engineer or contractor. The welder fabricates the beam to match those specifications and confirms fit before welding connections.
How long does it take to install a structural beam?
A single beam installation typically takes four to eight hours depending on access, height, and connection complexity. Multi-beam projects may require a full day or more, especially if temporary supports are needed.
What happens if the existing structure is out of square?
If the structure is not aligned, the beam can be shimmed or adjusted at the connection points to fit correctly. The welder works with your contractor to confirm the beam sits level and the load transfers properly.
Can you reinforce an existing building without replacing the beams?
Yes, reinforcement can be added by welding new steel alongside or beneath existing beams, or by installing cross bracing to stiffen the structure. This approach restores strength without full replacement.

If you are planning a structural upgrade, opening a load-bearing wall, or reinforcing an existing building in Johnston, reach out to Rhoades Welding LLC to confirm beam specifications and coordinate installation.